top of page
Search

Double check the bash plate install

  • buaans
  • Jun 19, 2019
  • 1 min read

The bash plate is not installed at the factory, it is a dealer job to put it on when uncrating the bike. At least one dealer installed it incorrectly, not installing a bracket (#5 below). While you're at it check that the canister vent is correctly clipped.

Source: KTM Spare Parts Catalog: Chassis


Recent Posts

See All
Faulty Brake Light Switch sensor

Some bikes are suffering from a faulty Brake Light Switch sensor, usually the rear one. If the stop light is permanently turned on, this...

 
 
 
Early clutch failures

There has been a few clutch failures, at fairly low mileage, and the people affected have been quite vocal as very few of the failures...

 
 
 

コメント

bottom of page